TR 20 round nuts with trapezoidal thread POM

SG 20x10 P2 l right-hand thread l five-start l outer diameter 36mm l length 32mm l POM l based on DIN 380

Properties

Our trapezoidal leadscrew nuts have a right-hand motion thread. This is multi-start and is suitable for combination with our steel or aluminum spindle tubes. The spindle nut with trapezoidal thread is made of POM (plastic). This gives the round nut good sliding and wear properties. In addition, high heat resistance and dimensional stability can be counted among its properties. With a nominal thread size of 25mm, two different thread designs can be selected: 

• SG 20x10 P2 (Thread pitch 10mm P2 l five-start - right-hand thread)

Application

The trapezoidal lead screw nut forms a drive solution in combination with our trapezoidal lead screws. This unit is used for the transmission of large axial forces and the conversion of rotating movements into linear ones. The system of spindle and nut is self-locking and usually requires no additional locking when at rest. By matching the nuts to the spindles, running noise and smoothness can be optimized. This enables application even in noise-sensitive areas.

Ketterer Antriebe supplies trapezoidal lead screw nuts for all trapezoidal lead screw spindles from stock. In addition to our POM version, discover other round nuts in brass and round nuts in PA6-GF30 as well as our selection in different shapes:

Flange nut with trapezoidal thread in POM or brass

square nut with trapezoidal thread in POM

You would like to combine your nut with a suitable spindle? Then it is worth taking a look at our range of spindles:

Trapezoidal thread spindle in steel or stainless steel

Spindle tubes with trapezoidal thread in steel or aluminum

For further information on round nuts with trapezoidal thread, please refer to the downloads listed below.

Back to the overview